New-england-arbors VA94431 Manual de usuario

Busca en linea o descarga Manual de usuario para Para Casa New-england-arbors VA94431. New England Arbors VA94431 User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 3
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Check Boxes for These Contents (1 Box)
In the event of missing or defective parts please call our customer service dept. at
1 800 282 9346, ext #20
(Mon. to Fri. 8:00 AM to 4:00 PM EST).
1. Lamp Post Top (1) 5” x 5“x 58”
2. Post Coupler (1)
3. Lamp Post Bottom (1) 5” x 5“x 14”
4. Post Cap (1)
5. Base Molding Trim Cap (1)
6. Base Molding Post (1)
7. Base Molding Bottom Insert (1)
8. 1-1/2” Screws (4)
9. Vinyl Weld Glue (1)
10. Post Trim (1) - Included with the Sturbridge/Burton Lamp Post
Tools You Will Need
Wheelbarrow or bucket (to mix concrete)
Tape Measure
• Level
• Shovel
Purchased Separately
• Lamp.
• 4x4 Pressure treated lumber. - 8’ long
Two bags of pre-mix concrete. *
* Strongly recommended for the stablility of this product.
General Information
Read Instructions through carefully before beginning assembly.
When handling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
We recommend an area approx 10’x 8’ for unobstructed handling.
Important Note:
• Please refer to local codes before installing outdoor lighting. UF-rated cable should be used for
underground wiring and all materials should be approved by the Underwriters Laborator (UL).
New England Arbors assumes no liability for errors, ommissions or the outcome of any project.
The Madison/Sturbridge/Trinity/Burton
Lamp Post
Please read through before starting assembly.
ASSEMBLY INSTRUCTIONS
1
1
Ver 5/AUG 2013
8
Not to Scale
4
9
Madison/Trinity Lamp Post Sturbridge/Burton Lamp Post
10
6
7
3
2
5
Vista de pagina 0
1 2 3

Indice de contenidos

Pagina 1 - Lamp Post

Check Boxes for These Contents (1 Box) In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346, ext #20 (M

Pagina 2 - Base Molding Assembly

2STEP TH RE EApply a generous amount of vinyl glue to the inside base of the postcap and place over the top end of the lamp post as illustrated.ST EP

Pagina 3 - OP TI ON AL

3Lamp Post Installation3605 32nd st. Building 3, Port Huron MI USA 48060Toll Free Phone: 1 800 282 9346 Toll Free Fax: 1 877 464 9286www.newengla

Comentarios a estos manuales

Sin comentarios